Where to get a 2 stroke cylinder replated/fixed in DFW?

[Jordan Pence]

Where can I get a 2 stroke 125 cylinder fixed? Just picked up a yz125 (luckily it was real cheap) and the cylinder is trashed bad. I am pretty sure the PO installed the piston and didn't put the circlips in right It popped out and totally scratched the walls of the cylinder.

I know there are a few out there that do this but I have no idea where to go or if I should just buy a used/new cylinder off ebay.

Can the replaters fix pretty much any damage? Will it cost me a lot to send it off?

Trying to spend as little as possible to get this thing going again considering I only paid 300 for the bike.

[Brandon Orr]

I will get a name of a good place for you.
I had them nickel plate my old 125 cylinder a long time ago.
My friend always uses them.

[Brandon Orr]

Langcourt plating

[Jordan Pence]

Langcourt plating

Awesome Thanks!!!

[Jordan Pence]

Dang, looks like it's going to end up costing ~250. I think I'm going to just buy a decent cylinder off eBay and hope for the best.

[Brandon Orr]

Yeah it is not cheap but when I did mine it stood up to several top ends.

[Joe Lopez]

Dang, looks like it's going to end up costing ~250. I think I'm going to just buy a decent cylinder off eBay and hope for the best.

Sounds like the logic i had with my engine this year.
But, after getting "messed" over with three ebay engines......i finally sent my original one to get rebuilt.
Hopefully you'll get the better end of the ebay experience than i had.
Where as if you got the replating method you'll at least know it's back to the right specs.
Good luck.

[Brandon Orr]

Did you call them Jordan or just go off the website pricing?

[Dave Felio]

Did you call them Jordan or ...?

I just tried it. It only confused them.

[Mitch Williams]

Powerseal USA does the best plating. Millenium is my second choice. Stay away from US Chrome.