Page 1 of 2 12 LastLast
Results 1 to 10 of 16

Thread: 2013 Kawasaki ZX-10R, fully race ready, open to competitive offers

  1. #1
    Senior Member
    Join Date
    Dec 2011
    Location
    Carrollton, TX
    Status
    Expert
    Bike #
    628
    Posts
    485

    2013 Kawasaki ZX-10R, fully race ready, open to competitive offers

    My interest in racing and riding has decreased a lot over the past year+, and I feel that I’m ready to leave the sport.
    Am open to competitive offers, for a one take-all on all the following, bike and the extras.
    I don’t have any active pictures to post with the forum listing right now, but will do that and update the listing later

    2013 Kawasaki ZX-10R
    Bike was purchased brand new, from Irving TX Kawasaki, in February 2015

    With the original dealership purchase, did 350 miles on the street for safe break-in effort, and then have only done 17 track day events, and only 8 sprint races
    Mileage is currently only 2741, with sprockets at higher mileage

    Armor Bodies body work (Superbike tail)
    Rear Shock, Ohlins TTX GP (KA 340)
    Front Fork internals, FGK 216 (completely new fresh service – new oil and seals, July 2017)
    Steering Damper - Ohlins SD 021 (still have factory damper too)
    Clutch (new July 2017) (I was ignorant, and didn’t have it setup correctly)
    Bazzaz, full setup with quick shifter (ECU has been flashed, putting out 187 HP)
    M4 race exhaust
    Steel Braided brake lines, Spiegler S-KA0339, https://spieglerusa.com/blog/Rennspo...s-by-Spiegler/
    BMC Air Filter
    Vortex rear set (with some spares)
    Clip on’s, Renthal
    GB Racing, case savers (3-piece set)
    Woodcraft frame sliders
    Woodcraft swing arm slider spools
    CRG RC2 race levers (brake / clutch)
    Attack Link
    Sprockets, 520 kit, Renthal (-1 / +2)
    Chain, DiD 520
    Windscreen, Zero Gravity
    Shorai battery, LFX14L2-BS12
    Brake pads, Carbone Lorraine C60 race pads
    Cox radiator guard

    GPS, GPX Pro 4, fully wired for RPM, etc (I want to sell this with the bike as an add-on perk, rather than go through the trouble of dismounting it and the wiring, and selling it alone)

    I will gladly include all the following too, for appropriate payment! (again, I would like to just sell it all, in a one-time sale)
    All the original factory body work is available
    Pit Bull strapless Trailer Restraint System
    ST Stands strapless transport http://www.motodracing.com/strapless-transport-stands
    Pit Bull front stand with triple-tree support, and rear stand
    T-Rex front stand with triple-tree support, and rear stand
    TechSpec tank pads, never opened

    I have all documentation available for the bike, I keep everything, even all my fuel tracking in an Excel file, etc
    Have all the original boxes of all the parts put on the bike, etc

    Please send me a PM through the site, and I will respond at my earliest convenience
    YouTube "N7HEVN"
    2011 / 2012 / 2013 / 2016, #628

  2. #2
    Senior Member
    Join Date
    Dec 2011
    Location
    Carrollton, TX
    Status
    Expert
    Bike #
    628
    Posts
    485
    Added item which I forgot to list ----- Brembo 19 RCS Master Cylinder
    I also have several take-off tires, with very good rubber still left on them, which would be provided in a sale
    YouTube "N7HEVN"
    2011 / 2012 / 2013 / 2016, #628

  3. #3
    Senior Member
    Join Date
    Sep 2009
    Location
    Newport News, VA
    Bike #
    54
    Posts
    247
    pm sent
    DWAYNE BROWN

  4. #4
    Senior Member
    Join Date
    Sep 2009
    Location
    Newport News, VA
    Bike #
    54
    Posts
    247
    I'm not sure if my pm are going through as one are showing inmusent folder. Please email me at your earliest sgtdoodoob@yahoo.com
    DWAYNE BROWN

  5. #5
    Senior Member
    Join Date
    Dec 2011
    Location
    Carrollton, TX
    Status
    Expert
    Bike #
    628
    Posts
    485
    bump

    pictures available here -
    https://drive.google.com/drive/folde...lU?usp=sharing

    I forgot to put the tail section on, when taking photos, it does fit fine, I just didn't put it on at the time
    YouTube "N7HEVN"
    2011 / 2012 / 2013 / 2016, #628

  6. #6
    Senior Member
    Join Date
    Dec 2011
    Location
    Carrollton, TX
    Status
    Expert
    Bike #
    628
    Posts
    485
    Bump
    Still for sale
    YouTube "N7HEVN"
    2011 / 2012 / 2013 / 2016, #628

  7. #7
    Senior Member
    Join Date
    Dec 2011
    Location
    Carrollton, TX
    Status
    Expert
    Bike #
    628
    Posts
    485
    Bump
    Still for sale
    YouTube "N7HEVN"
    2011 / 2012 / 2013 / 2016, #628

  8. #8
    Senior Member
    Join Date
    Dec 2011
    Location
    Carrollton, TX
    Status
    Expert
    Bike #
    628
    Posts
    485
    Bump
    Still for sale
    YouTube "N7HEVN"
    2011 / 2012 / 2013 / 2016, #628

  9. #9
    Senior Member
    Join Date
    Dec 2011
    Location
    Carrollton, TX
    Status
    Expert
    Bike #
    628
    Posts
    485
    I appear to have forgotten Title information. Title is clear / clean.
    YouTube "N7HEVN"
    2011 / 2012 / 2013 / 2016, #628

  10. #10
    Senior Member
    Join Date
    Dec 2011
    Location
    Carrollton, TX
    Status
    Expert
    Bike #
    628
    Posts
    485
    Bump
    Still for sale
    YouTube "N7HEVN"
    2011 / 2012 / 2013 / 2016, #628

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •