Search:

Type: Posts; User: James DeFrain

Page 1 of 3 1 2 3

Search: Search took 0.68 seconds.

  1. Replies
    1
    Views
    893

    New track for CMRA?

    During the riders meeting there was mention of a race track CMRA was attempting to negotiate races. What was the name of the track?
  2. Replies
    1
    Views
    1,167

    Nevermind, the "P" is for lower face protection,...

    Nevermind, the "P" is for lower face protection, full face.
  3. Replies
    1
    Views
    1,167

    Helmet, specs

    Looking at helmets and the spec is ec 22-05, but the rule book states ec-22-05 "p". Is the same?
  4. Replies
    3
    Views
    1,688

    Talked with Jim, but ended up working from home...

    Talked with Jim, but ended up working from home so I ran through the trouble shooting again. I'm a little embarrassed to say it was the spark plug that failed! I've never had a plug quite working,...
  5. Replies
    3
    Views
    1,688

    Triumph Daytona - diagnostic & repair

    2014 Triumph Daytona with Bazzaz EFI tuner, one of the primary injectors is not working. I tested the injectors and all test good, so am in need of someone who can test an repair. Any suggestions...
  6. Replies
    2
    Views
    1,068

    William, three questions 1) approximately how...

    William, three questions 1) approximately how many miles are on the engine, 2) has the bike been raced, 3) when was the last time the bike has been run?
  7. Replies
    3
    Views
    1,254

    Sold

    Sold
  8. Replies
    3
    Views
    1,254

    Sold 11-8-19

    Sold 11-8-19
  9. Replies
    3
    Views
    1,254

    For Sale: Kendon Dual Stand up trailer

    Selling a Kendon Dual Standup trailer $1000.00, located in the Houston area. I can bring it to MSRH the weekend of Oct 28th.

    contact James
  10. Replies
    3
    Views
    1,682

    My mistake, I ground the hole in the original...

    My mistake, I ground the hole in the original Triumph stator cover. After reading these posts I will be installing the Woodcraft covers. Thanks
  11. Replies
    3
    Views
    1,682

    Woodcraft side covers.

    Inquiring if anyone has used the Woodcraft stator cover? I ground a hole in my left side cover and trying to decide if I should go back with the original cover than fit with a plastic cover, or spend...
  12. Replies
    18
    Views
    4,117

    your right about the tire pressure as I checked...

    your right about the tire pressure as I checked them right off the warmers. I was surprised by how little traction I had and these tire ran great the last race of the season at MSRH. Hopefully I'll...
  13. Replies
    18
    Views
    4,117

    So Sundays race was a lessons learned as the...

    So Sundays race was a lessons learned as the track was dry so I went out on the Summer tires, which proved to be a mistake as I went down on turn 12 the back end slid out. I noticed rain tires being...
  14. Replies
    18
    Views
    4,117

    Probably wait until race weekend with the...

    Probably wait until race weekend with the expectation of having to purchase tires, but will confer with tire vendor for recommendations. I'm trying to limit exposure to newbe mistakes and at this...
  15. Replies
    18
    Views
    4,117

    Good advice I'll check with David, I was hoping...

    Good advice I'll check with David, I was hoping to be little more prepared in the case of a cold track, but the weather here in Houston just shifted 50 degrees in a couple of days so probably won't...
  16. Replies
    18
    Views
    4,117

    I always use tire warmers, but if the weather and...

    I always use tire warmers, but if the weather and track are cold not sure the tires will hold the heat to keep them from turning to stone. I have a set of Bridgestone rs10 that are pretty gummy even...
  17. Replies
    18
    Views
    4,117

    So just street tires? Not the racing DOTs that...

    So just street tires? Not the racing DOTs that require warmers.
  18. Replies
    18
    Views
    4,117

    Cold weather tires

    With the race approaching in Feb what are the limitations of race DOT tires? I am currently running the Bridgestone R10 (2) which are great for my riding level when warm, but are like stone when...
  19. Replies
    11
    Views
    3,931

    I found a company who straightens and refurbishes...

    I found a company who straightens and refurbishes wheels for moslty auto, but services bikes as well. the price was $125.00 vs the $660.00 the freindly folks at Triumph quoted. Trying to post before...
  20. Replies
    11
    Views
    3,931

    Very good, thanks for the insight.

    Very good, thanks for the insight.
  21. Replies
    11
    Views
    3,931

    Wheels made in China?

    While at Friday practice (TWS) I drove wide on turn 4 and bent the rim on the front. In the search for a wheel Im seeing alot of wheels made in China and I am questioning the quality. I work for one...
  22. Replies
    14
    Views
    4,522

    Thanks all, this was the feedback I was looking...

    Thanks all, this was the feedback I was looking for, particularly the " Not running around like a chicken with its head cut off" as that was my concern.
  23. Replies
    14
    Views
    4,522

    Race scheduling

    My first race (Prov Nov) is June 18 at TWS I'm going to run race 5 C-Super stock & race 21 formula 40 MW. I am considering running race 3 but unsure if there is enough time between races 3 and 5? Any...
  24. Triumph rear calipers

    My Daytona has the same setup, what if anything needs to happen to pass tech?
  25. Replies
    3
    Views
    1,493

    The suspension was just tuned recently so sag and...

    The suspension was just tuned recently so sag and all feels good, just having to muscle it through the corners - sometimes not so well. Thanks for the caution on how much to adjust at one time, I'll...
Results 1 to 25 of 65
Page 1 of 3 1 2 3