Who made the one you have? Esjot? Think I got lost on how you got one but cannot get more.
Who made the one you have? Esjot? Think I got lost on how you got one but cannot get more.
Provisional Expert #98
http://www.motorcycle.com/news/harle...ell-88821.html
http://www.sportrider.com/erik-buell...s-receivership
These articles should answer your questions! Show some compassion! Jimmy, please excuse this Austin Hipster! LOL!
BOHICA-ModClassic Champ
Lame Duc Racing
Sport Rider Coaching #43 ULWE
Torquasaurus #10 BBE-F2 Champ
Maybe you could use an adaptor like this.
Provisional Expert #98
A large production run of these in 16, 17 and 18 tooth sizes was done years ago as part of the Buell race program. When Buell was shut down, EBR took over race-specific parts, while HD was left Buell OEM/street parts. These came over to EBR.Originally Posted by Josh Henke
A few years back, I ordered a number of these, and a few seasons later, I'm down to my last 16-t. They seem to last about season or season and a half. I have a couple of 17-t, so if push comes to shove I can go to a longer chain and larger rear sprockets, but I'd rather not.
The reason the part number turned out to be a goose chase is race parts for EBR aren't distributed by Parts Unlimited, only street parts are. So, basically, what I need exists, it exists in quantity, and it's owned by a guy from New Jersey who had a couple of million lying around to buy EBR out of receivership. I gotta wait until he comes back on line and gives me a way to order them, apparently. Or, get them from Esjot directly.
It's nuts, I tell you.
CMRA Expert #101
EBR 1190RX, Large BGE
I'd be more than happy to see what it would take for them to supply. If they've made them before it's a simple matter of putting them on order. If they need to custom make them it would be best if you could send me a used example so we get it right the first time. Please note that we've had some 40t rears on order since February so as I hinted above, patience will be required.
As a former knuckle dragging drag racer, why don't you just make the part? Call Mark Williams. They build their own car drag racing rear differential parts and can cut splines. Have the splines cut into a steel sleeve. TIG weld said sleeve onto pre-case hardened or a Chrome-Moly sprocket. Chopper guys do it all the time. Yes their motor's make less power, but the bikes weigh a hell of a lot more though. No it won't be cheap, but it is an option.
Also, as long as the splined section is in good shape you could just cut the worn out sprocket off and TIG weld on a good one. Again, an option.
Using Tapatalk
Posting Permissions
